#! /bin/sh
#
# rc.inet1	This shell script boots up the base INET system.
#
# Version:	@(#)/etc/rc.d/rc.inet1	2.00	10/06/1999
#

HOSTNAME=`cat /etc/HOSTNAME`

# Attach the loopback device.
/sbin/ifconfig lo 127.0.0.1
/sbin/route add -net 127.0.0.0 netmask 255.0.0.0 lo

# IF YOU HAVE AN ETHERNET CONNECTION, use these lines below to configure the 
# eth1 interface.

# Edit these values to set up a static IP address:
IPADDR="PUT_IT_HERE"	# REPLACE with YOUR Cable Modem's IP address.
NETMASK="PUT_IT_HERE"	# REPLACE with YOUR Cable Modem's netmask.
BROADCAST="PUT_IT_HERE"	# REPLACE with YOUR Cable Modem's broadcast address
GATEWAY="PUT_IT_HERE"	# REPLACE with YOUR Cable Modem's gateway address.

# Set up the ethernet card:
  echo "Configuring eth0 as ${IPADDR}..."
  /sbin/ifconfig eth0 ${IPADDR} broadcast ${BROADCAST} netmask ${NETMASK}

#eth0 = to cable modem
#eth1 = internal LAN

  echo "Configuring eth1 as 192.168.1.1..."
/sbin/ifconfig eth1 192.168.1.1 broadcast 192.168.0.255 netmask 255.255.255.0

  # If that didn't succeed, give the system administrator some hints:
  if [ ! $? = 0 ]; then
    cat << EOF
Your ethernet card was not initialized properly.  Here are some reasons why this
may have happened, and the solutions:
1. Your kernel does not contain support for your card.  Including all the 
   network drivers in a Linux kernel can make it too large to even boot, and
   sometimes including extra drivers can cause system hangs.  To support your
   ethernet, either edit /etc/rc.d/rc.modules to load the support at boottime,
   or compile and install a kernel that contains support.
2. You don't have an ethernet card, in which case you should comment out this
   section of /etc/rc.d/rc.inet1.  (Unless you don't mind seeing this error...)
EOF
  fi

  # If there is a gateway defined, then set it up:
  if [ ! "$GATEWAY" = "" ]; then
    /sbin/route add default gw ${GATEWAY} netmask 0.0.0.0 metric 1
  fi
fi

# End of rc.inet1